595 replies to this topic

[Oldskoolbaby]

Now that I know how to put up pictures, heres my project so far. Its currenly waiting for its respray and engine and then it should be ready. Any thoughts on what could be better?

Attached Files

•  CIMG0576.JPG   164.39K   222 downloads

[Oldskoolbaby]

This is the car with its group 5 arches, buckets and the rest of the mods to date.

Attached Files

•  Picture_031.jpg   90.11K   236 downloads

[P91MER]

yes, i think them wheels should be on mine!!!!! they are sweeet!!

seriously tho mate, looking REAL nice with the 10's!! a roll cage will go nicely with them buckets aswel!!

keep up the good work!

Rich

[CharlieBrown]

Wow, nice alloys!!!!!

THats one nice mini.

Nice and shiny!

[Guess-Works.com]

Nice job, especially with the yoko's... I assume you've gone to 7.5 or 7.9" disks and have not spacered the 10's out to fit over the 8.4's ?

[Dom]

sweet mini, what exhaust you got?

[Oldskoolbaby]

Ye, Ive gone for 7.5 inch S gear and drilled disks and EBC greenstuff. With the end so light i can get the rear wheels off the floor at 90mph with the pads warm.

[Boab]

Whats your operating system mate?

[Oldskoolbaby]

Its a got 1.85 inch stainless steel RC40 millenium zaust. Its not too big and doesnt zap power like some of the large bores. It sound lush. Ive got a recordin on my pc but im not sure weather i can put it up on the forum? :wink:

Attached Files

•  CIMG0612.JPG   148.9K   45 downloads

[Dom]

cool mines 1.75" single pipe on left side

[Oldskoolbaby]

Heres a picture of my big boy toy. Its a 1275 a seires block(pre A-Pus) Offset bored to 74 mm (1400 or 1399). Its been modified for nitrous with a full race 37/31mm head. Its conducted by a kent 286 cam and duplex timing chain. The box is a sccr built by myself and supplied by minisport. The carbs a Hiff 44 for now but when its worn in and ive got used to the extra power I will probable put 2 of these on alongside the nitrous.

Attached Files

•  Picture_060.JPG   70.68K   88 downloads

[Oldskoolbaby]

This is a close up of the head. Its modified for nos but in this pic it was not quite finished. After this shot it was skimmed, had new guides and was fully ported but only polished on the exhaust ports as i beleive you can loose power if you do the inlets.

Attached Files

•  Picture_052.JPG   81.21K   48 downloads

[Bungle]

the chrome trim around the top of the doors (like MK 1) looks good on a dark car :grin:

[Oldskoolbaby]

Your completely right. I love that but i cant find anywhere that do the stuff. Ive looked at the mini shows but still no luck. Great mind think alike A.

[Bungle]

like this ? cant remember where i bought it at one of the mini showes :smartass: