My Twinky Build

Posted 07 March 2010 - 09:29 PM

Hi all,

Been reading alot of your builds and asking loads of questions so I thought I'll repay everyone by sharing my project on here too!

First of all here is my mini during its first restoration:

 DSCN0266.JPG   858.04K   8 downloads

 DSCN0267.JPG   789.38K   5 downloads

 DSCN0270.JPG   830.54K   4 downloads

After working through the birds nest of cables I managed to neaten it up and install my new dash and steering wheel

 mini_dash_2.JPG   187.73K   5 downloads

 mini_steering.JPG   190.07K   5 downloads

Unfortunately I did not take many pictures of the mini complete as I was too excited about driving it but here is one after the respray:

 Image004.jpg   147.39K   5 downloads

Then I had a short somewhere killing the battery every other day so traced it back to behind the dashboard and once it was all in bits again I decided that its a good time to take the engine out and make that my next project.

 SP_A0075.jpg   874.81K   5 downloads

Edited by shinerwright, 07 March 2010 - 09:51 PM.

• Back to top

Posted 07 March 2010 - 09:35 PM

• Back to top

Posted 07 March 2010 - 09:36 PM

• Back to top

Posted 07 March 2010 - 09:37 PM

Nope no pictures

• Back to top

Posted 07 March 2010 - 09:53 PM

• Back to top

Posted 07 March 2010 - 10:32 PM

Once the engine was out I decided to tidy and repaint the engine bay:

Primed








Finished

• Back to top

Posted 08 March 2010 - 02:12 PM

Heres some pictures of the subframe and setup:





Thought I would paint the suspension and hubs etc whilst waiting for my engine bits to arrive

• Back to top

Posted 08 March 2010 - 02:14 PM

looks good....guessing you like green then???

• Back to top

Posted 08 March 2010 - 03:21 PM

Thanks, just don't like wasting paint

Thought I would be different and have it all matching.

• Back to top

Posted 08 March 2010 - 03:26 PM

• Back to top

Posted 08 March 2010 - 03:28 PM

Ooo another 'close-by' TMF'er, I'll be watching this thread closely


It's looking good Well done

• Back to top

Posted 08 March 2010 - 07:21 PM

Here are my Minisport alloy calipers after I assembled them (they are the best buy of the build so far):







Assembled the subframe in my bedroom as I was running out of space:

• Back to top

Posted 09 March 2010 - 11:06 AM

• Back to top

Posted 09 March 2010 - 08:34 PM

Got the subframe installed on the mini with a bit of hassle but all good now:


brakes got a little rusty being in the garage for a while


Finally what I have been building up to - the engine project!!

Refurbished gearbox with X-pin diff and a 3.44 final drive:

Reground and balanced crankshaft:

Flywheel housing:

1380 Block with centre main strap:

Conversion plate for K1100:

The 16v K1100 Head:

• Back to top

Posted 10 March 2010 - 01:26 PM

Here are some pictures of the engine build although I can't find any of the crank and piston installation:

• Back to top