Hiya, I've got my original black (but now faded grey) wing mirrors off my car. I want to repsray them silver to match the body work, but I cant seem to get the mirror bit out - you can usually take this stuff apart cant you? theres a little hole in the bottom - which i've tried to lever the mirror bit out with but i dont want to break them! :gasp:
Spraying Wing Mirrors!
Started by
stirx
, Aug 23 2005 10:52 AM
8 replies to this topic
#1
Posted 23 August 2005 - 10:52 AM
#2
Posted 23 August 2005 - 10:58 AM
Or just try lots of good masking tape and mask off the lens? Must be easier than risking damage to it.
#3
Posted 23 August 2005 - 11:02 AM
yea, i guess! cheers!
#4
Posted 23 August 2005 - 11:08 AM
clubmankatiebf did exactly that with my mirrors, and sprayed them black, they look great, took about 10 mins to mask them up!
#5
Posted 23 August 2005 - 11:14 AM
sounds good, but im not sure if i want to spray the black edging (arond the face of the mirror) too, you see im painting them silver, and i want a bit of contrast i think lol
... here the hole, and you can see what i mean about the black trim around the edge?
... here the hole, and you can see what i mean about the black trim around the edge?
#6
Posted 23 August 2005 - 11:18 AM
i think the hole is to let water out :smartass:
#7
Posted 23 August 2005 - 11:21 AM
mask that off as well then
just make sure that your masking tape is straight and well stuck down and take your time.
i did these in a couple of hours!
just make sure that your masking tape is straight and well stuck down and take your time.
i did these in a couple of hours!
#8
Posted 23 August 2005 - 11:26 AM
you could mask over the mirror glass and the black part, then plastic prime and spray the rest of it, should be a problem, use a sharp knife to get a good edge on the masking where you want it to stop...
(oops, sorry Pooky, had the reply window open for a few minutes before I replied, so didn't see your post!)
(oops, sorry Pooky, had the reply window open for a few minutes before I replied, so didn't see your post!)
Edited by Minis84, 23 August 2005 - 11:27 AM.
#9
Posted 23 August 2005 - 11:26 AM
i think the hole is to let water out
oops lol :nugget:
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users