Jump to content


Photo
- - - - -

Problem Getting Car Into Gear When Cold


  • Please log in to reply
5 replies to this topic

#1 Corey96Williams

Corey96Williams

    Speeding Along Now

  • Members
  • PipPipPipPipPip
  • 316 posts
  • Location: Wales

Posted 08 October 2015 - 10:31 PM

Hi,

 

I left work today and sat in the Mini for a solid 5 minutes, waiting for it to warm up before driving anywhere as it was very cold. I found first gear had to be jammed in, and with reverse it was like having no clutch. Is this as simple as the oil being too cold? I use 20w50 oil if this helps.

 

Thanks,

Corey.



#2 Swift_General

Swift_General

    One Carb Or Two?

  • Members
  • PipPipPipPipPipPipPip
  • 870 posts
  • Location: England

Posted 08 October 2015 - 10:39 PM

I'd be looking at the clutch initially.

#3 Spider

Spider

    Moved Into The Garage

  • Admin
  • PipPipPipPipPipPipPipPipPipPipPip
  • 13,904 posts
  • Location: NSW
  • Local Club: South Australian Moke Club

Posted 08 October 2015 - 11:26 PM

If it's OK when warmed up, I'd say the Oil Viscosity is probably to high.



#4 Corey96Williams

Corey96Williams

    Speeding Along Now

  • Members
  • PipPipPipPipPip
  • 316 posts
  • Location: Wales

Posted 09 October 2015 - 09:53 PM

Today the car was terrible, the clutch itself is definitely going I think. Wouldn't go into gear, clutch drops to the floor with no feel and the biting point is a lot lower. Just a month before I wanted to put it into hibernation too  >_<



#5 spiguy

spiguy

    Camshaft & Stage Two Head

  • Members
  • PipPipPipPipPipPipPipPip
  • 1,537 posts
  • Location: UnderTheCar

Posted 09 October 2015 - 10:15 PM

sounds like a lack of pressure in the hydraulic system. Could be a leak, eg slave cylinder / master cylinder resulting in air getting in. Any signs of fluid leaking anywhere (either around the slave cylinder or if master cylinder, maybe drips of fluid in the drivers footwell). You could top up and bleed initially, should prove if it is just hydraulic, then find the underlying cause if it is.



#6 Corey96Williams

Corey96Williams

    Speeding Along Now

  • Members
  • PipPipPipPipPip
  • 316 posts
  • Location: Wales

Posted 09 October 2015 - 10:26 PM

sounds like a lack of pressure in the hydraulic system. Could be a leak, eg slave cylinder / master cylinder resulting in air getting in. Any signs of fluid leaking anywhere (either around the slave cylinder or if master cylinder, maybe drips of fluid in the drivers footwell). You could top up and bleed initially, should prove if it is just hydraulic, then find the underlying cause if it is.

That's what I'm planning to do tomorrow  :gimme: Hoping it'll do it






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users