18 replies to this topic

[sonikk4]

So were on the floor pan is the alignment points?

 

The way you are asking i assume you know the answer then???

[Steve220]

So were on the floor pan is the alignment points?

 
The way you are asking i assume you know the answer then???

I think he meant 'where'.

There are no alignment point per say. It was done on the jig when the boy was made. There is a PDF of measurements floating around the internet somewhere.

[midridge2]

Steve220, thank you for pointing out the spelling mistake, spelling was never my strong point as school, many years ago. lol. 

Neil, when some one reads a posting, the reader cannot see the body language or if not said verbally the tone of voice, because of this, I think you may have miss understood me, I apologise if that was the case it was never intended. 

I was taught if you never ask questions you will never learn, so I only was asking a question so I can learn. 

[sonikk4]

Steve220, thank you for pointing out the spelling mistake, spelling was never my strong point as school, many years ago. lol. 

Neil, when some one reads a posting, the reader cannot see the body language or if not said verbally the tone of voice, because of this, I think you may have miss understood me, I apologise if that was the case it was never intended. 

I was taught if you never ask questions you will never learn, so I only was asking a question so I can learn. 

 

Fair shout, it is difficult sometimes to interpret what folks do actually mean but no problem.

 

As to what points you would use on a mini shell to ensure alignment etc is correct well that is still a puzzle. I would have thought suspension pickup points would be an ideal place as these should be fixed. That is of course unless they have been damaged.