8 replies to this topic

[Larson250]

Hi,
Now that I've finished the mini I have a roll over jig to get rid of.
It has been slightly modded so that the front arms can go through where the grille fits, allowing the bonnet to be positioned whilst on the jig.
Has slight surface rust and would benefit from a coat of paint.

Asking for £175.00 cash on collection from Leicestershire.

The picture shows the same model but it isn't the exact one.

Attached Files

•  IMG_0170.JPG   29.26K   22 downloads

[CAU998]

Hi,

 

Don't suppose you'd know the overall length including the feet once fitted to a saloon shell? Got to try and fit it within a 14.5 foot space.

 

Cheers

[Larson250]

Hi,
What I can do is measure the jig from where it fits on the mini to the end, (if that makes sense). I think it will be towards that length however I used it in a single integral garage without too many issues.

I will post tomorrow,

Dean

[CAU998]

Brilliant, spot on! Thanks very much!

[Larson250]

Measured and took photos of the jig today.

These are approx sizes so don't quote me on them but from the tower bolt where the front of the jig fits to the end of the feet on it is 125cm.
And from the rear shock hole in the boot to the end of the feet on the jig is about 110cm.

I think with the body mounted on it you are looking around the 13'6" to 14' mark

I hope that helps,

Dean

Attached Files

•  IMG_0172.JPG   67.25K   19 downloads
•  IMG_0171.JPG   70.65K   20 downloads

[CAU998]

Hi, really sorry about my late reply. I'm definately interested, do you reckon with it dismantled it'd fit in the back of an Astra? Where abouts in Leicestershire are you located? PM me if you prefer.

 

Cheers, Curtis

[Larson250]

PM's sent

[minisprint]

Interested pm me a contact number

[Larson250]

Thanks for the interest, but I'm afraid the jig is provisionaly sold and being colllected on the 26th.

If this falls through I'll let you know.

Regards,
Dean