Jump to content


Photo

A Little Progress - I Think


  • Please log in to reply
No replies to this topic

#1 Aridgerunner

Aridgerunner

    Stage One Kit Fitted

  • Noobies
  • PipPipPip
  • 73 posts
  • Location: Montoursville PA
  • Local Club: None

Posted 22 March 2017 - 01:01 PM

Had to take a break from the mini project over the winter but did a little work yesterday.  

 

I cut out a lot of rusty metal and poor work done by the PO.  Because I can not afford to buy any more sheet metal parts from the UK for this car, at least for a long time, I will be fabricating what is missing in this picture. I do have the rear valance closing assembly and the rear wheel arch stiffener.  So, it's just a matter of fitting in the section of boot floor and making the wheel arch section that I cut out.  Then I'll install the subframe and use it as guide to locate the holes in the floor.  Once that is done I should then be able to weld in the rear valance closing assembly and the rear wheel arch stiffener.

 

if I'm way off base with my plan please, somebody, let me know where i might be going wrong.  Thanks in advance for your help.

 

Bill

Attached Files






1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users