I've seen many demonstrations on how to remove the flywheel, but non on how to put it back on... is this a simple job or am i missing something?
PLEASE ADVISE! :)
Posted 11 July 2017 - 12:17 PM
I've seen many demonstrations on how to remove the flywheel, but non on how to put it back on... is this a simple job or am i missing something?
PLEASE ADVISE! :)
Posted 11 July 2017 - 12:25 PM
fairly. all covered in your Haynes manual.
note it might be an idea to lap it with the crank to get a nice finish just remember to clean all the paste off after.
Also note the different locking tabs for the early and later types of clutch assys.
Posted 11 July 2017 - 03:04 PM
make sure you do it good and tight, somone I know used 115 ft lb rrather than 150 and it came loose.
personally I warm them up a bit and then stick them on and torque them up quick, also do them a bit over 150 pluce a heave, probably about 175-180 ft lb. its always worked for me.
0 members, 1 guests, 0 anonymous users