1 reply to this topic

[malc_west]

Hi guys and girls looking for some advise on a mini shell that I'm prepping for a respray. I'm doing a bare metal project and I'm hand stripping it but I'm struggling to get through the last bit of old primer on some tight corners and particularly where the old spot welds are slightly sunken so any advice on these hard to reach bits or am I being over fussy? Also should I seem seal welds before or after priming? Thanks once again

[sonikk4]

Twisted wire sup on a grinder will get into most places. Other than either use Paint stripper or do it by hand. Time consuming but does the job.
Primer first, use a epoxy primer then seam seal.