17 replies to this topic

[absx2]

That take off pipe is standard equipment on Carbed coopers and the MG Metro which has the same engine.

 

Its an anti run off valve as the factory couldn't stop them running on due to the excess ignition advance required to keep the emissions down at idle.

[MiniJosh92]

very nice !

 

Do you not use a spot welder?

 

Also what is the take off on servo pipe? Ive not seen that before!

 

Thanks. Yep I spotweld where possible. And what absx2 said about the anti run on valve,

 

That take off pipe is standard equipment on Carbed coopers and the MG Metro which has the same engine.

 

Its an anti run off valve as the factory couldn't stop them running on due to the excess ignition advance required to keep the emissions down at idle.

[MiniJosh92]

MOT this afternoon. Just the badges and final couple of little jobs left to do.

 

Attached Files

•  DSC_0920.JPG   57.56K   0 downloads
•  DSC_0922.JPG   50.13K   0 downloads
•  DSC_0923.JPG   53.58K   0 downloads