Ive purchased replacement half floor assemblies with the outer sill attached from M Machine. Nice Fresh but bare metal!!
Before I fit them I intend to paint the cavity between inner and outer sill, however i'm drowning in research and cant decide where to start.
I plan to de-grease surfaces using thinners, should I then give it a rub over with with Scotch-Brite before applying primer?
Should I use an etch primer before applying a primer?
What type of primer should I use? should I use a cellulose primer or is this porous?
Do I need to apply a top coat?
I was planning on using rattle cans for this, i do have access to one of those hobby sprayers if that opens up a wider range of paint to use.
finish is not important as it wont be seen.
bought SAS Zinc primer to flash over welds etc before having the car painted but I don't think this is suitable for finishing bare metal.
Looking forward to the advise.