2 replies to this topic

[Sprok]

Ive posted on the SPI tech thread but so far nobody replied so i thought Id try here.

Im rebuilding an SPI and am trying to figure out the route the rear harness takes. Older minis I know the harness routes up behind the fuel tank, up the rear pillar and along the n/s roof chanel then down the front door pillar

Mine is an SPI and im sure I remember it routing behind tank throught the side of the seats into the ns compartment bin then forward along the floor and up the toeboard and bulkhead ending behing the dash.

Could any kind hearted sould possibly enlighten me as its really stopped progress ! Hope you can help

Many Thanks
Sprok

[cal844]

The loom goes along the floor then up the side of the seat then to the tank

[the.stroker]

This question has been answered in your other thread.

http://www.theminifo...ing-loom-route/

I’ve closed this thread otherwise you will end up with two threads on the same subject.