1 reply to this topic

[JCmini]

Just had a 3d geometry done. 

I kind of understand the reading however can some one with better knowledge explain to me the results. In general I think all four corners were toeing in and now the front are set straight. 

The rear left looked toed in a lot. Is this an issue or does it seem ok?  My rears are fixed however I had seen you can by shims to get it back out. Just dont know how many to buy. 

 

Any advice would be great.

 

thanks 

 

 

 

[Steve220]

Without fully adjustable lower arms, tie arms and rear adjusters, it will be difficult to get it bang on. Camber on the front is related to how low the car is, mine (even after adjustment) was still negative camber.