4 replies to this topic

[1bonjing19]

Auto & motor out, Replaced with Pre A+ 1275 and dam 2886 rod box.

Sensor relocated to trigger wheel on front crank pulley.

So far......

Earthed outer shield on sensor line.

Have ignition spark at 8: btdc.

fuel pump runs to prime injector body, and stops as per normal.

Engine will fire on crank, but fails to continue to run.

Injector pulse has fuel at cranking  but not have fuel to run, so it appears the fuel pump is not re starting after normal shut down.

Your interest, please.

 

Final idea will be to return to normal distributor and an HS4, with fuel tank, etc to match...

 

However, as I have fuel to start, and spark, I would prefer to retain spi...

Thanks. .

(i'm in New Zealand).

[Johnmar]

Have you read this topic: http://www.theminifo...after-starting/

 

The symptoms look alike.
 

[1bonjing19]

Thanks, Johnmar.

Been all through hoses, temp unit, wire connections to coil, inertia switch correct.

?? ---???/

[sonscar]

I would check that the coil and injector has power whilst in the run position ie not cranking.This may require some thought.Good luck.Steve..

[1bonjing19]

Thanks.

Coil has power in 'run / on ' switch position. I'll run a probe to the white wire in the injector to check. Thanks. (9.12 pm, so tomorrow)..