Hi, I've had this bonnet release kit hanging around the garage for months now and havn't got round to fitting it yet...does anyone know where to start? any help would be very much appreciated!!
thankyou!
Luke
Bonnet Release Kit
Started by
Lucas-Minster
, Oct 18 2007 05:44 PM
8 replies to this topic
#1
Posted 18 October 2007 - 05:44 PM
#2
Posted 18 October 2007 - 05:53 PM
the front
#3
Posted 18 October 2007 - 05:58 PM
At the bonnet
#4
Posted 18 October 2007 - 08:11 PM
nicee...just wanted to know how to connect it..
#5
Posted 18 October 2007 - 08:35 PM
open the bonnet and remove the catch on the slam panel (2 bolts) fit the new catch in its place
run cable from this catch around the engine bay into the car
fix bracket under dash and mount pull
check it works
job done
run cable from this catch around the engine bay into the car
fix bracket under dash and mount pull
check it works
job done
#6
Posted 18 October 2007 - 08:47 PM
Im my experience, keep the grille off if possible as if the catch feels like being annoying, then the bonnet wont open and the screws at the top wont come off when the bonnets closed!
#7
Posted 18 October 2007 - 08:49 PM
ah...thanks guys..wer can i put the pully thingy inside the car?...(duc tape to the dash board ?...lol)
#8
Posted 18 October 2007 - 08:54 PM
mines under the dash between the steering column and the little switch panel on the right hand side
#9
Posted 19 October 2007 - 11:59 PM
I think you're going to have to drill a hole through the bulkhead for the cable though?
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users