B16A2 Weekend Clubby Racer

I was bored of spending stupid money on small things in the a series ie primary gear washer (£30) it's silly

I'm going to go for a clubby front I think mate not sure yet and I havnt got any look forsale mate sorry

Sry must have misread, good luck with the build.

Oh I do have engine loom sorry but that's guna go as part of a full conversion

Took gesrbox off today out engine on the stand ready to strip the head off for cambelt , water pump and head gasket

Thought id try the cam cover on

Edited by minilee94, 20 September 2015 - 08:32 PM.

Good call with vtec. I love them personally...

 

Did you ever drive the 1380 mini you built lol?

Yeah a few times but wanted more of a challenge and wanted so thing different

Removed the i tire loom for abit of space removed the wiper motor to give it a clean up and possibly a Dsn cover

Also took the heater out save abit of weight :)
Iv also decided to keep the round nose front but I'm going to fit the rad in the boot with a few scoops and fans

Just swapped a my heavy duty cv joint with a set of freshly welded and sleeved shafts also found out I can use normal mini arms with the allspeed frame so I'm going to trial that over the weekend and possibly fit the new frame .

Iv just bought a lighnted flywheel 3.4kg supposed to 9 kg to go with my stage 1 clutch and some skunk 2 cam gears won't be dialed in yet till I get some itr cams



Plan of this weekend is to do heady gaksket , and cambelt ,water pump and do frame I hope ..

Edited by minilee94, 01 October 2015 - 06:17 AM.

Spare cover I had smoothed and painted

That colour is amazing. Bet you can't wait to get it in!

Looking good so far :)

Thanks abit of a downer but cam pulley bolts don't fit so guna sell them and buy some new pulleys

Thought you were selling this?