Gear Rod And Gear Stick
#1
Posted 14 January 2018 - 08:15 PM
#2
Posted 14 January 2018 - 09:02 PM
Is it a rod change or remote type ?
#3
Posted 14 January 2018 - 10:01 PM
#4
Posted 14 January 2018 - 10:04 PM
then the rod seal and then wear in the remote box where the stick goes in.
#5
Posted 14 January 2018 - 10:26 PM
GEARBOX ROD CHANGE ANTI OIL LEAK SEAL KIT:-
https://www.minispar...ic/MSSK050.aspx
Edited by mab01uk, 14 January 2018 - 10:26 PM.
#6
Posted 14 January 2018 - 10:28 PM
#7
Posted 14 January 2018 - 10:47 PM
Where the gearstick locates onto the ball noticed a load of bolts around that section of the unit am I alright to removed all these to disassemble and clean everything?
no idea where you are now. have a look at your manual as most of this is covered in them.
or include images so we actually know what you are on about.
but to answer your question sure as long as you are aware of what might jump out and know how to reassemble it.
even looking at the minispares web site will give you a clue
http://www.minispare...ism.aspx?1~4~44
Edited by nicklouse, 14 January 2018 - 10:48 PM.
#8
Posted 14 January 2018 - 11:02 PM
Looking at on here there isn't much other than the retainer pin and steady bush but actually looking at it in real life it looks as if the housing can be dismantled
#9
Posted 14 January 2018 - 11:22 PM
yes 12 can be removed just make sure you note the orientation.
11 is held onto 1 and 6 by roll pins
4 id held in place by washers and a nut inside the housing.
#10
Posted 14 January 2018 - 11:35 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users