Good morning, I have an issue with getting my mini to run.its a mini city e 1988. I've owned it for 33years but has been garaged for the last 20. I can get it running for about 30 secs then it revs like mad and then dies. Leave it a while and then it does the same again. I've changed all the usual parts, plugs leads points etc and cleaned the carb as best as I can.need to move the car soon to get welding done and dont fancy pushing it to driveway. Garage is in a block so not just pushing it out of garage!!😫😫. Any help would be appreciated to at least keep it running for longer than 30 secs.
2 replies to this topic
#1
Posted 16 September 2021 - 07:39 AM
#2
Posted 21 September 2021 - 08:24 PM
I had a similar issue where the revs would be really high on start up, turned out to be the advance/retard vacuum pipe from the distributor to the carb that had split on both ends. Might be worth checking, only a couple of quid to replace.
Edited by Li4mk, 21 September 2021 - 08:25 PM.
#3
Posted 25 September 2021 - 11:52 PM
Thanks, this had rotted whilst it was stored so have replaced. Was told this could be the problem but no luck.
Also tagged with one or more of these keywords: engine
Mini Technical Sections →
Problems, Questions and Technical →
Milky Oil In Rocker After Not Draining Water Before Removing HeadStarted by jezjsa , 11 Mar 2024 engine |
|
|
||
Mini Technical Sections →
Problems, Questions and Technical →
Speeduino EcuStarted by cooperpooper , 09 Mar 2024 electrical, engine |
|
|
||
Mini Technical Sections →
Problems, Questions and Technical →
Mini Now Wont StartStarted by jezjsa , 25 Feb 2024 engine |
|
|
||
Mini Technical Sections →
Problems, Questions and Technical →
Rough Running On Standard CoilStarted by Sweep16 , 09 Feb 2024 electrical, engine |
|
|
||
Mini Technical Sections →
Problems, Questions and Technical →
Duplex Timing Chain Sprockets Alignment IssueStarted by Timrobins , 22 Jan 2024 engine |
|
|
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users