I removed the engine steady bracket to repair a cracked crossmember but stupidly didn't measure the bracket's position.
Could some kind soul give me the dimension from the top of the cross member down to the bracket (see arrow in photo).
[attachment=74380:Drawing1_d.jpg]
Help Needed.
Started by
SolarB
, Nov 11 2008 08:27 AM
6 replies to this topic
#2
SolarB
-
- Members
-
- 1,387 posts
One Carb Or Two?
- Location: Surrey
Posted 11 November 2008 - 05:45 PM
Anybody this evening?
#3
SolarB
-
- Members
-
- 1,387 posts
One Carb Or Two?
- Location: Surrey
Posted 11 November 2008 - 11:41 PM
Small bump.
#4
Ethel
-
- TMF Team
-
- 26,011 posts
..is NOT a girl!
- Local Club: none
Posted 12 November 2008 - 12:13 AM
Haven't got one to measure but it will be the same as the assembled engine steady bar.
#5
SolarB
-
- Members
-
- 1,387 posts
One Carb Or Two?
- Location: Surrey
Posted 12 November 2008 - 08:18 AM
Yes, problem is I haven't got a steady bar with rubbers at the moment.Haven't got one to measure but it will be the same as the assembled engine steady bar.
#6
Scotauto
-
- Members
-
- 335 posts
Speeding Along Now
- Location: Denmark
Posted 12 November 2008 - 08:25 AM
here you are sir.. 28mm from the top of the croosmember tothe top of the bracket. Just in case it is 84mm from the right side of the left strengthener to the bracket. Hope that helps.
Jason
Jason
#7
SolarB
-
- Members
-
- 1,387 posts
One Carb Or Two?
- Location: Surrey
Posted 12 November 2008 - 11:06 AM
Jason, you're an absolute star, that's my evening sorted out.here you are sir.. 28mm from the top of the croosmember tothe top of the bracket. Just in case it is 84mm from the right side of the left strengthener to the bracket. Hope that helps.
Jason
Cheers,
Graham.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
