11 replies to this topic

[Margie The Mini 1275]

what is this any help please email me <<address removed, please use PM>>

thanks

Attached Files

•  mini_problem.jpg   399.35K   25 downloads
•  mini_problem__2_.jpg   432.83K   15 downloads
•  mini_problem__1_.jpg   392.03K   14 downloads

Edited by Dan, 28 December 2008 - 11:47 PM.
Posting personal e-Mail addresses in the forum is a bad idea. If people send you a forum PM you will be notified by e-Mail anyway.

[THE ANORAK]

what ever it is, it looks like the cover is missing

you need wait for one of the fuel injection guys to come along

Edited by THE ANORAK, 28 December 2008 - 12:36 PM.

[Shifty]

Might be worth asking to have this topic moved to the injection section?

[Cooper-202S]

what is this any help please email me [email protected]

thanks

Looks like the guts relay module that is mounted on top of the brake servo.
But it's definitly missing a cover.

(Its item 8 inthe picture in the Haynes manual page 1.4/5 if you have one to hand)

[Ethel]

It's the relay module. Have a look to see if there's an empty plaggy box above the brake pedal linkage.

[L400RAS]

That is the MEMS relay module, engine management stuff, and yes it should have a cover on it;

The relay module is located in the engine compartment adjacent to the engine control module.
The relay module contains the following relays:
• Main relay - energised when the ignition is switched on and supplies power to the ECM.
• Fuel pump relay - energised by the ECM for a short period when the ignition is switched on, during cranking and while the engine is running.
• Starter relay - energised by the cranking signal from the ignition switch.
• Heated oxygen sensor (HO2S) relay - energised by the ECM and supplies current to the heated oxygen sensor element.




HTH
Ryan.

Edited by L400RAS, 28 December 2008 - 12:55 PM.

[Sprocket]

That is the MEMS relay module, engine management stuff, and yes it should have a cover on it;

The relay module is located in the engine compartment adjacent to the engine control module.
The relay module contains the following relays:
• Main relay - energised when the ignition is switched on and supplies power to the ECM.
• Fuel pump relay - energised by the ECM for a short period when the ignition is switched on, during cranking and while the engine is running.
• Starter relay - energised by the cranking signal from the ignition switch.
• Heated oxygen sensor (HO2S) relay - energised by the ECM and supplies current to the heated oxygen sensor element.




HTH
Ryan.

Common missconception on the SPi that the relay pack supplies power to the oxygen sensor. It does not, it supplies power to the manifold heater instead


What is the real question being asked here?

[Margie The Mini 1275]

hi everyone thanks so much for telling me i have a cover for it
when i turn the ignition the fuel pump doesnt come on but if i push the switch it does
is it dodgy wiring
thanks
carnon

[Margie The Mini 1275]

and also do you have one that i can buy off you it is for a 1995 mini mayfair 1275
thanks

[Margie The Mini 1275]

it needs to be a YWB 10022
thanks

[Dan]

The fuel pump runs when you push what switch?

[Margie The Mini 1275]

on the engine management relay