31 replies to this topic

[benpopham]

I cant hold back.. heres the spec

998cc Block + 0.40'' Pocketed
compression ratio of 10.5 to 1
AE +0.40'' pistons press fit
Swiftune 12G940 stage 3 head
3.4 ratio final drive
hardened diff pin
wedged & backdrilled Crank
lightened rods
Weber DCOE45 using one side (Mini7 spec)
Swiftune SW5-07 cam
Swiftune timing gears
Swiftune Straight cut roller drop gears 1:1
Titan 1.3 ratio Roller Rockers
Swiftune ultralite pre-verto flywheel
Ultralite billet Swiftune back plate
Orange diaphragm
Maniflow se7en's manifold
Maniflow stage 2 LCB
Carbon 4 blade Fan
Lightened ISKY cam followers
PoleStar engine management system

[Reece Jackson]

nice spec is that ben i have sorted the problem with the rockers now it turns out that the cylinder head is skimmed that much that the 1275 pushrods that were supplied with the engine are two long now i have fitted 998 ones and it is fine i didn't go for rollers as have we have tested both before i dont think there is a real advantage in having them cheers

[benpopham]

any progress on this?

[Reece Jackson]

yes ben there has been i just haven't had chance to post lately.I have bought a 3 syncro sccr box for the engine and a few other little bits and bats but there isn't much to see in the pictures it is hard for me as im only 16 and on a minimum wage so its hard to keep up with it.i have also ordered my bn weber 45 and 40mm chokes jets etc so there will be some major progress when that and my gearbox arrives and then it will be on to the rolling road were i hope im not dissapointed!!

[Reece Jackson]

i shall now go outside and do a spot of manifold porting and see how that goes

[liirge]

Any news on this one mate?

[Reece Jackson]

oh yes what just about to update actually i got the manifold all ported and have just bought another new gearbox of ebay 4 sync sccr full recon with lincon plate type lsd 4.1 cwp for £550 bargain will put some pictures up in a min

[Reece Jackson]

got a shiny new rev counter for xmas aswell!!

Attached Files

•  class_4_stuff_001.jpg   470.46K   15 downloads
•  class_4_stuff_002.jpg   382.37K   8 downloads
•  class_4_stuff_003.jpg   263.09K   7 downloads

[Reece Jackson]

Edited by Reece Jackson, 03 January 2010 - 03:55 PM.

[Reece Jackson]

picture showing rear suspension setup it looks a bit tatty at the minute though

[Reece Jackson]

this engine might have to be for sale due to just getting laid off offers?? pm me

[liirge]

wish you had offered it to me about 6 months ago mate!
Nice porting work there!

[Reece Jackson]

im in two minds whether to sell it to be honest its took me that long to get what i consider to be a good spec lol

[Reece Jackson]

the engine and car is now on ebay sorry guys!!

[liirge]

Linky?