Doh, yep I did mean mm35m thats massive...... did you mean 35mm by any chance
......
Also the cv joints in question were also a very tight fit in the new bearings, so maybe it wasn’t just the cv nut that was machined to the wrong size.
Do I Need A Torque Wrench
Started by
dale.lavender
, Jan 17 2011 07:42 PM
76 replies to this topic
#76
1984mini25
-
- Members
-
- 8,782 posts
Crazy About Mini's
- Location: -
Posted 21 January 2011 - 06:24 PM
Also the cv joints in question were also a very tight fit in the new bearings, so maybe it wasn’t just the cv nut that was machined to the wrong size.
#77
MRA
-
- Banned
-
- 7,607 posts
Previously known as 'mra-minis.co.uk'.
- Location: Due to move again....
Posted 21 January 2011 - 07:44 PM
When you say a tight fit...... you are probably talking microns, everything has a tolerance, the bearings are made to a much higher tolerance level, typically 1 tenth of a micron on a bearing that size is about right.
The CV would be made slightly "less" tight on the tolerancing and would be about 2 to 5 microns, some will be very tight, some will be an easy slide fit and all the rest should be in between..... I am guessing that you had to press it in ?
The CV would be made slightly "less" tight on the tolerancing and would be about 2 to 5 microns, some will be very tight, some will be an easy slide fit and all the rest should be in between..... I am guessing that you had to press it in ?
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
