5 replies to this topic

[minibarmy]

Unfinished exhaust manifold to mount T2 turbocharger.

Manufactured from 304 Stainless steel tube, Dia 1 1/2" (38mm) x 2.2mm Wall thickness

You get everything as shown in the picture.

The flanges are profiled to fit a T2 turbocharger, the main tube has been over bent to a right angle, i wanted the ends at a slight angle into the end ports on the head, a little heat should pull these out the the correct position.

The centre tube has been codsmouthed to fit excellently over the main tube & left long to trim to required length.

All thats left to do is cut the ends to the desired angle & length you want to mount this, weld on all the flanges & centre tube making sure you cut the hole first! & cut the hole for the turbo inlet.

This is a kit of parts that requires a small amount of work to complete.

A mirage manifold will cost approx £300

£120 lot.

[minibarmy]

Now on e-bay!

[mad mk1]

Hi mate, is the Reserve £120

[minibarmy]

Hi mate, is the Reserve £120

No, I want these parts gone & out the way so i've reduced the reserve but I'm not going to give them away as these are worth a fair bit in labour alone.

Edited by minibarmy, 02 February 2011 - 09:05 PM.

[mad mk1]

Hi mate, is the Reserve £120

No, I want these parts gone & out the way so i've reduced the reserve but I'm not going to give them away as these are worth a fair bit in labour alone.

Hi mate, i have just won it on ebay but it did not get to the reserve.
so can we come to a deal.

[minibarmy]

Hi mate, is the Reserve £120

No, I want these parts gone & out the way so i've reduced the reserve but I'm not going to give them away as these are worth a fair bit in labour alone.

Hi mate, i have just won it on ebay but it did not get to the reserve.
so can we come to a deal.

Still have it, make me an offer i can't refuse.