2 replies to this topic

[Tamworthbay]

I am running a project at the special school where I work to build a mini to go hillclimbing in. All the kids involved have physical or learning disabilities. We have got a cheap project car to start on but it has a few holes (well lots if I am am honest). does anyone have an old/ scrap shell that they could cut out a couple of panels we can use to repair ours? We need the front tranmission tunnel section, rod change type (the bit in front of the crossmember) and a parcel shelf - early type without holes. We have to raise every penny for the project so low cost is very important, we do have some bits we can swap and I have an ex BL toolmaker as my oppo so we could make bespoke bits in trade if that helps. We can also collect within a wide area.

[100ev8]

i got a folder, bender and a swager you can borrow if you need them .got a door and a bootlid

[Tamworthbay]

i got a folder, bender and a swager you can borrow if you need them .got a door and a bootlid

Thanks, PM sent