Hi all
i have put a new rear subframe on my car and rebulit the radius arms
looking from the back the two wheels are turn in
is there a adjustment that can be done to adjust it
i have adjustable brackets for the radius arm but these only allow the radius arms to move up and down
anybody have this problem as well what cause this problem
Thanks dave
Back Wheels Turned In
Started by
087dave
, Oct 16 2011 08:14 PM
1 reply to this topic
#1
Posted 16 October 2011 - 08:14 PM
#2
Posted 16 October 2011 - 08:21 PM
You need to check it accurately - not just 'look at it' . Use a length of dead straight timber - hold it against each rear wheel in turn, at hub height - pointing forward. This will show you (relative to the shell) if it's one wheel that 's wrong, or both. If confirmed wrong - make a simple track gauge and measure it up . The outer mounting brackets for the trailing arms can have the hole filed forward/upwards to get the tracking correct at 1/16" toe IN, and the camber angle spot on at dead upright or possibly half a degree negative depending on your preference.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users