Basically, i would like to know which pipes go where on a servo assisted brake master cylinder. Ie. Which is the front/rear brake outlet port?
Appreciate any input
Brake Master Cylinder Pipe Routing
Started by
Bash Master
, May 05 2012 07:26 PM
2 replies to this topic
#1
Bash Master
-
- TMF+ Member
-
- 150 posts
Mini Mad
- Location: Blackpool, Lancashire
Posted 05 May 2012 - 07:26 PM
Hi guys, tried searching for an answer but have had no luck.
Basically, i would like to know which pipes go where on a servo assisted brake master cylinder. Ie. Which is the front/rear brake outlet port?
Appreciate any input
Basically, i would like to know which pipes go where on a servo assisted brake master cylinder. Ie. Which is the front/rear brake outlet port?
Appreciate any input
#2
tiger99
-
- Members
-
- 8,584 posts
Crazy About Mini's
- Location: Hemel Hempstead
Posted 05 May 2012 - 07:51 PM
I described it here very recently.
http://www.theminifo...cylinder-servo/
The Somerford Mini web site and the Rover manual are good sources of info, if in doubt.
http://www.theminifo...cylinder-servo/
The Somerford Mini web site and the Rover manual are good sources of info, if in doubt.
#3
Bash Master
-
- TMF+ Member
-
- 150 posts
Mini Mad
- Location: Blackpool, Lancashire
Posted 05 May 2012 - 09:23 PM
Ah good i wasn't sure and it only crossed my mind today that i could have done it wrong. Luckily i did it right, phew.
Thanks again
Thanks again
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
