7 replies to this topic

[minilee94]

Anyone else had experience with Paul inch engineering in Plymouth

Anyone think this is a good price

REBORE 1380 OFF SET
FIT PISTONS TO RODS
MAIN STRAP
SURFACE CLEAN
DRILL II STUD IN BLOCK
HEAVY DUTY RACE MAIN BEARINGS
HEAVY DUTY RACE BIG END BEARINGS
HEAVY DUTY RACE THRUST WASHERS
DUMMY BUILD to get c/r
HEAD GASKET SET
CONVERSION SET
276 OR 286 KENT CAM
OIL PUMP
INSPECT CYLINDER HEAD AND RECONDITION
COMPETITION FOLLOWERS
CENTER OIL PICK UP PIPE
NEW CORE PLUGS
OIL WAYS & WATER WAYS CLEANED
NEW CAM BEARINGS
All in at £910 what you think

[minilee94]

Am thinking of sending engine to them

And im getting a med crank

Edited by minilee94, 30 January 2013 - 05:29 PM.

[danny1]

every engine ive had from him, refuse to keep the core plugs secure, always fourcing them out

[minilee94]

Oh right okay

[Bungle]

he built my 1330 engine about 6 years ago and it's run faultlessly since

he was very helpful with advice on the phone and even made time to show me around the machine shop and a few race minis that he does the prep for

i know Bluemini (a member from long ago) used him a few times with no problems and Crocks (another member from long ago) also uses him and recommended him to me

[minilee94]

Yeah he was a very helpful man on the phone

And this is the problem your always guna get 2 different opinions

[MRA]

What are your expectations ? are you expecting a high performance engine or a cheaper budget engine ?

[The Matt]

It's not a bad price. As Bungle says a few people off here have used him and been happy. I know Bluemini used to rate him really highly