Jump to content


Photo

Vibe Component Install Help


Best Answer tonykart19 , 29 April 2013 - 09:17 PM

the two terminals were so the tweeter could be mounted in the center of the speaker  

Go to the full post


  • Please log in to reply
3 replies to this topic

#1 tonykart19

tonykart19

    Passed Test

  • Noobies
  • PipPip
  • 26 posts

Posted 13 March 2013 - 08:50 PM

i have the vibe black air component set i got them secondhand, speakers cross overs and tweeters
firstly the speakers have 4 terminals, 1 pos and neg saying 4ohms going to the cone area, and another pos and neg saying 4ohms going down towards the magnets, what are these?

second the tweeters have sealed wires on them (i think) and a black and black with a white stripe wire coming out, is the stripe one likely to be the pos?

also what size cable should i use cause i was going to use 4mm flex cable but the cross overs terminals are tiny!

cheers

#2 Ruckus

Ruckus

    Ice Ice Baby!!!

  • Members
  • PipPipPipPipPipPipPipPipPip
  • 2,071 posts
  • Location: Top of the hill in Kent
  • Local Club: SMOC

Posted 13 March 2013 - 11:14 PM

Can you take a pic of the back of the mids.

And a quick test for polarity for the tweeters, if you see the (little) cone but the leads on to a AA or 9 volt Battery, when you have the + and - wired correctly the cone will come forward if it's the wrong way around it will go backwards. :D

#3 tonykart19

tonykart19

    Passed Test

  • Noobies
  • PipPip
  • 26 posts

Posted 14 March 2013 - 05:35 PM

oh clever, il get a pic tomorrow thank you

#4 tonykart19

tonykart19

    Passed Test

  • Noobies
  • PipPip
  • 26 posts

Posted 29 April 2013 - 09:17 PM   Best Answer

the two terminals were so the tweeter could be mounted in the center of the speaker  






1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users