Attached Files
-
IMG_0935.jpg 200.57K
54 downloads
Minispares layshaft
Started by
rob3
, Apr 22 2006 09:29 PM
5 replies to this topic
#1
rob3
-
- Noobies
-
- 99 posts
Stage One Kit Fitted
Posted 22 April 2006 - 09:29 PM
1500 miles old, in a 1040 putting out 63bhp / 68ft lbs. Imagine the damage in a 1380 etc... The picture says a 1000 words;
#2
v8mini
-
- Members
-
- 726 posts
One Carb Or Two?
- Local Club: Minis on the run
Posted 22 April 2006 - 09:48 PM
might be just the pic, but to me it looks a bit too silver, as if its not been heat treated, should it normally be duller looking or greyish ??
#3
rob3
-
- Noobies
-
- 99 posts
Stage One Kit Fitted
Posted 22 April 2006 - 09:52 PM
When i punched it out, the punch left a dent in the end. And these are the worlds shitest punches
#4
dklawson
-
- TMF+ Member
-
- 10,923 posts
Moved Into The Garage
- Name: Doug
- Location: Durham, NC - USA
- Local Club: none
Posted 23 April 2006 - 02:32 AM
On another board I frequent this very problem was discussed. I can't remember which vendor is developing "good" layshafts... but it wasn't MiniSpares.
#5
mambaman
-
- Members
-
- 162 posts
Mini Mad
Posted 23 April 2006 - 06:56 AM
i belive JKD are selling good ones, available from them and minispeed (i think). I havent checked it out as i've taken the polocy of using good second hand ones from 998 a+ gearboxes.
#6
The Matt
-
- Admin
-
- 17,232 posts
You don't escape that easily.....
- Name: Matt
- Location: Overton, North Wales
- Local Club: Welsh Border Minis
Posted 23 April 2006 - 10:21 AM
1500 miles old, in a 1040 putting out 63bhp / 68ft lbs. Imagine the damage in a 1380 etc... The picture says a 1000 words;
I have heard that Minispares layshafts are actually no stronger than cheese!! I have seen a few threads on them actually, I think there was one on turbominis.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
