Hi, this must of come up more than once, sorry to ask again. I am changing from cast remote to rod type linkage ( due to a new gearbox). What is the best way to change the tunel, to mount the new rod change or other ideas for gear selection, this is to go into a hill climber. 
Changing Gearbox Linkage Type (Body Work)
Started by
tom1
, Jul 29 2013 07:11 PM
3 replies to this topic
#1
tom1
-
- Members
-
- 323 posts
Speeding Along Now
Posted 29 July 2013 - 07:11 PM
#2
tom1
-
- Members
-
- 323 posts
Speeding Along Now
Posted 30 July 2013 - 03:23 PM
Ok, change of tack. Could someone please take a photo of the floor pan/ tunnel on a rod type gear shift, so I can try and fabricate something like. Thanks 
#3
Ethel
-
- TMF Team
-
- 26,580 posts
..is NOT a girl!
- Local Club: none
Posted 30 July 2013 - 03:46 PM
It should be easy to go from remote to rod. Just fit the selector, sans gearstick, and mark where to cut the hole. It only touches the tunnel via the rubber mounting bobbins, just a couple of bolt holes.
#4
minidaves
-
- Traders
-
- 4,933 posts
Up Into Fourth
- Location: kent
- Local Club: mine
Posted 30 July 2013 - 05:51 PM
fit the linkage, and then make a bracket and drill 1 hole for one bobbing, job done
2 user(s) are reading this topic
0 members, 2 guests, 0 anonymous users
