6 replies to this topic

[Supersouthward87]

So I've been enjoying the forum, I particularly like 101 things to know about your mini, an important one was all the bits go back in the engine bay, so saying That, what is this piece?

Silly question I know.

 

It's a rubber washer about 25mm (1") in diameter with a 6mm hole with a sleeve in it. Recently I took the end clutch housing apart to check the clutch release bearing and was wondering if it's a seal from the slave cylinder rod but it all looks ok and the haynes manual doesn't mention it specifically but I know it's not an idiot proof guide (unlucky for me).

 

 GOPR0195.JPG   35.88K   55 downloads

 

 GOPR0193.JPG   41.22K   25 downloads

 

also hello all, I'm Jack and I own Jeff :)

Edited by Supersouthward87, 01 November 2013 - 10:10 PM.

[the_samkingdon15]

So I've been enjoying the forum, I particularly like 101 things to know about your mini, an important one was all the bits go back in the engine bay, so saying That, what is this piece?
Silly question I know.
 
Edit: I can't upload the photo for some reason? It's a rubber washer about 25mm (1") in diameter with a 6mm hole with a sleeve in it. Recently I took the end clutch housing apart to check the clutch release bearing and was wondering if it's a seal from the slave cylinder rod but it all looks ok and the haynes manual doesn't mention it specifically but I know it's not an idiot proof guide (unlucky for me).

that's kinda vague without a picture

[Supersouthward87]

Try now

[ryan22_lgm]

That's the grommet for the speedo cable through the bulkhead !

[the_samkingdon15]

what he said ^

[Supersouthward87]

superb, time to work out which one is the speedo cable and then what a bulkhead is, cheers!

[the_samkingdon15]

speedo cable is the one that goes through the bulkhead (rear of engine bay if I'm not mistaken) into the back of the speedo/clock setup..