8 replies to this topic

[Jordie]

Hello

 

anyone with a car handy or a flipfront etc, can you measure the widest points, height of the front panel etc etc.

 

Im looking to see if a clubman front will fit into a 2008 megane hatchback with seats etc down?

 

Jordie

[Colinmac1330]

Well I had one in the back of a metro! lol. Only stuck out a little so i used a bungee to hold the tailgate down.

[Jordie]

Front and bonnet to collect tomorrow.

Dont want to resort to having boot open. Hopefully it will fit in

[Colinmac1330]

I'm sure it will as it darn near fitted in the metro, although it was fibreglass so was probably a bit more flexible than a steel one?

[Colinmac1330]

[Jordie]

it is a fibreglass front. looking at that picture, should go in our lasses megane. i was worried about the size of the area between arches and the boot opening.

 

Ive had a roundnose in a mk1 micra but had to drive back with seats right forward.

[sonikk4]

Jordie these are rough measurements but A panel flange to A panel  flange is 140 cms. From the back of the wing to the nose of the bonnet approx 90 cms.

[Jordie]

cheers pal

[Jordie]

Good job it was fibreglass and could flex a little. it fitted in with the wings flexed a little. a metal front end wouldnt have gone in with the boot shut.