6 replies to this topic

[JamesleppAFC]

Hi I live in bracknell,berkshire does anyone know a place that I can get my mini on a rolling road.

[HarrysMini]

Slark Race Engineering in Amesbury isn't too far from you.

 

Very good place, I would even go as far as saying probably the best in the area.

[JamesleppAFC]

Ok thanks I've never had it done before do you know how much roughly it's gonna cost me?

[HarrysMini]

Here is Slark Race Engineering's price list:

• Torque, bhp, transmission loss print out & speedo check including 2 or 3 runs  £40.00 + VAT
• Engine health check to include:Oil, coolant, plug and air filter, fuel and water hoses,compression check, speedometer check & torque,bhp, transmission loss print out  £70.00 + VAT
• Mapping, tuning and fault diagnosis  £60+ VAT per hour
• Half day hire of facility:09.00 to 13.00 hrs OR 13.00 to 17.00 hrs  £200 + VAT
• Full day hire of facility09.00 to 17.00 £300 +VAT

 

See their website here: http://www.slarkraceengineering.co.uk

Edited by HarrysMini, 30 January 2014 - 06:16 PM.

[DomCr250]

Minispeed is just down the M3 - have read good things about them.

 

Google says there is CFM engineering in Reading, but I've never seen them mentioned before.

 

Power Engineering used to be a really good one in Uxbridge - the old CCC magazine cars were often tested there, been going years.

 

Slark is one of the most experienced - but it's a long drive.

 

Whoever you use make sure they have been going sometime and have mini experience.

[JamesleppAFC]

Ok thanks for all the info.

[gazza01]

Get down to minispeed. Also called Britains horsepower for R/R