One is a genuine Rover plunger and the other is a Minispares non-genuine version.
Both are correct for the pre-verto clutch set-up.
Cheers, Steve.
Bloody Pre Verto Clutch!
Started by
brad-the-bear
, May 06 2014 05:44 PM
19 replies to this topic
#16
Stevie W
-
- Members
-
- 1,204 posts
One Carb Or Two?
- Location: Southampton
- Local Club: P&SMOC
Posted 06 May 2014 - 09:12 PM
#17
KernowCooper
-
- Mini Docs
-
- 7,847 posts
Sparkie
- Name: Dave
- Location: The South West
- Local Club: Kernow Mini Club
Posted 06 May 2014 - 09:19 PM
One has the type with a clip for the releae bearing and the other is plain shaft
#18
brad-the-bear
-
- Members
-
- 1,114 posts
One Carb Or Two?
- Location: under the bonnet
Posted 06 May 2014 - 09:19 PM
cheers guys :)
#19
Earwax
-
- TMF+ Member
-
- 577 posts
Super Mini Mad
- Location: Brisbane
Posted 06 May 2014 - 09:37 PM
If in the build you lapped the flywheel to the crank, with wok off check that the flywheel hasn't crept up the taper causing contact with the housing around the thrust bearing
#20
brad-the-bear
-
- Members
-
- 1,114 posts
One Carb Or Two?
- Location: under the bonnet
Posted 06 May 2014 - 09:41 PM
If in the build you lapped the flywheel to the crank, with wok off check that the flywheel hasn't crept up the taper causing contact with the housing around the thrust bearing
will do
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
