hi, anyone know what replacement points & condenser i can use for an aldon 100AY? (no vac advance)
cheers,
bear.
Aldon Yellow Dizzy Info 100Ay
Started by
brad-the-bear
, Jun 20 2014 08:33 PM
6 replies to this topic
#1
brad-the-bear
-
- Members
-
- 1,114 posts
One Carb Or Two?
- Location: under the bonnet
Posted 20 June 2014 - 08:33 PM
#2
KernowCooper
-
- Mini Docs
-
- 7,847 posts
Sparkie
- Name: Dave
- Location: The South West
- Local Club: Kernow Mini Club
Posted 20 June 2014 - 09:13 PM
Same fitment as the 45D as far as I know. I have the Aldon Ignitor in mine
#3
brad-the-bear
-
- Members
-
- 1,114 posts
One Carb Or Two?
- Location: under the bonnet
Posted 22 June 2014 - 08:22 AM
cheers pal.
#4
cal844
-
- Members
-
- 9,631 posts
Crazy About Mini's
- Location: Ballingry, Fife
- Local Club: TFMOC
Posted 22 June 2014 - 11:00 AM
Brad, why not upgrade to electrnic ignition??
#5
brad-the-bear
-
- Members
-
- 1,114 posts
One Carb Or Two?
- Location: under the bonnet
Posted 23 June 2014 - 11:38 PM
Brad, why not upgrade to electrnic ignition??
thought about it but i have a ballast ignition wire so i would have to replace it?
#6
KernowCooper
-
- Mini Docs
-
- 7,847 posts
Sparkie
- Name: Dave
- Location: The South West
- Local Club: Kernow Mini Club
Posted 23 June 2014 - 11:54 PM
No you could keep the ballasted ignition and run a new12v switched feed to the igniter red wire which would connect direct and the red is not on the coil + like a 12v system.
I would convert to a 12v system and get rid of the ballasted wire which causes lots of wiring loom damage when it burns out. Done lots its a major job, people think it wont happen to me ?
#7
cal844
-
- Members
-
- 9,631 posts
Crazy About Mini's
- Location: Ballingry, Fife
- Local Club: TFMOC
Posted 24 June 2014 - 09:38 AM
No you could keep the ballasted ignition and run a new12v switched feed to the igniter red wire which would connect direct and the red is not on the coil + like a 12v system.
I would convert to a 12v system and get rid of the ballasted wire which causes lots of wiring loom damage when it burns out. Done lots its a major job, people think it wont happen to me ?
When our 998 was swapped, we disconnected the resistor(Pink /white on Brads car) at both ends, then used crimp spade connectors to use the P/W, W connection for the new trigger wire, now we always have the old system available incase of problems
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
