Best Answer Ben_O , 15 January 2015 - 01:21 AM
as above.
A little tip, Put a small amount of blu-tak on the slinging bracket flanges with them bolted to the inner sill then position the outer sill on.
Once in position, push in around the slinging brackets before unbolting them and removing the sill.
if you are careful, the brackets will have stuck to the inner sill allowing you to mark their position, then simply remove them, remove the blu-tak and then you can place them back using the marks you made before.
Ben
Go to the full post
Mini Mad
Posted 14 January 2015 - 07:45 PM
Does anyone have the measurements for the inner sill, Where to weld the jacking points and the front and rear sill to floor reinforcing brackets? (the ones in the pictures)
My inner sills were rotten and couldnt take measurements and now have no idea where to put the new ones..
Thanks
Moved Into The Garage
Posted 14 January 2015 - 07:48 PM
Mill Road Garage
Posted 15 January 2015 - 01:21 AM Best Answer
as above.
A little tip, Put a small amount of blu-tak on the slinging bracket flanges with them bolted to the inner sill then position the outer sill on.
Once in position, push in around the slinging brackets before unbolting them and removing the sill.
if you are careful, the brackets will have stuck to the inner sill allowing you to mark their position, then simply remove them, remove the blu-tak and then you can place them back using the marks you made before.
Ben
0 members, 1 guests, 0 anonymous users
