5 replies to this topic

[WiredbyWilson]

Hi one and all,

 

Just a cheeky post to let you know that we have been updating our website with a products and prices page to allow you to see the growing range of products we are developing and the associated prices.

 

http://www.wiredbywilson.co.uk

 

Please feel free to enquire with us here or via email at [email protected]. When contacting us please let us have your TMF username as we offer a discount to TMF+ members.

 

 

On another note we are proud to announce we now have Trademark in the UK so you can be confident we are a genuine set up and that there is only one WiredbyWilson around. If you notice anyone else claiming they have products similar or like ours and using the logo / brand name please contact us for a thank you reward!

 

 

We look forward to working with you.

 

David

WiredbyWilson

Edited by Wilson1330, 20 May 2015 - 12:53 PM.

[cubby1701]

congratulations and best of luck. May I enquire about a custom loom for a mini with a Nissan micra engine conversion. I'm just after a rough estimate presently thanks

[silve1999]

looking good

[WiredbyWilson]

congratulations and best of luck. May I enquire about a custom loom for a mini with a Nissan micra engine conversion. I'm just after a rough estimate presently thanks

 

Hi cubby.

 

A full front end loom is our next project - as for incorporating a micra engine conversion that would be a lot of work. But having wired a Micra loom into a mini for Niki Parsons' "Nelly" I would advise keeping the two looms separate, that way allowing reversal at any point.

I'd also recommend that you obtain the full engine bay loom with the ecu - the car loom itself is not important, but if you are breaking an entire car keep everything!

 

Wiring the micra loom into the mini is an onsite job as well - i'd much prefer to do it in the car to make sure everything works as it is supposed to.

 

Many thanks

 

David

[cubby1701]

thanks David for your reply. I know it will be quite a while before I'm ready for wiring but would you be willing to come to northern Ireland when the time comes so I know its done properly

[WiredbyWilson]

Hi cubby,

 

We can talk about it nearer the time - but i'm based in Kent UK so would be a large amount of travel costs................. but happy to advise / help when the time comes.

 

David