4 replies to this topic

[limby2000]

I want a very good condition sw5 cam, I have a mg metro cam I was putting into my build but have been advised against as its an auto. Will pay good money for good condition, or could do a deal with my mg cam and money.

[[email protected]]

I have a suitcase full of cams i have collected, some Kent, some Piper, some Crane, also British Leylans special tuning.

Obviously they're not the specific one you have listed but I most likely have an equivalent.

 

If that is of interest, I will look up sw5 spec and see what is similar, I have Vizards Bibles so Icould also look it up in there.

 

All the best.

Stuart

[kezzkitkat]

I have a suitcase full of cams i have collected, some Kent, some Piper, some Crane, also British Leylans special tuning.
Obviously they're not the specific one you have listed but I most likely have an equivalent.
 
If that is of interest, I will look up sw5 spec and see what is similar, I have Vizards Bibles so Icould also look it up in there.
 
All the best.
Stuart

Would you have a Kent 266 by any chance?

[limby2000]

Still after cam, becoming more flexible on spec, must be a(high torque cam) similar to sw5.

[[email protected]]

These are my collection last time i wrote it, ithink there are a few more now too.   Yes, i know, i'm a horder...

Id/Markings     -     Drive     -     Lobe width     -     Lobe wear & pitting          -     Notes
                           -     Spider   -     13mm             -      None                                   -     Piper 300 i believe
HR 300              -     Spider   -     13mm             -      Some wear, no pitting     -      Piper i think or Kent?
MPI                    -     Slot       -      13mm            -      None                                   -     has oil ways
VP3C                        Slot       -      13mm            -      NEW                                    -     Crane cam - see vizard book - pretty special
VP3C                        Slot       -      13mm            -      No wear, v slight pitting   -     Crane cam - see vizard book - pretty special
Kent MD266           Slot       -      13mm            -      Minimal wear no pitting  -    has oil ways
HR3002                   Slot       -      13mm            -      No pitting, slight wear      -    3 rings
Unknown                Slot      -       13mm            -      No wear, no pitting           -    1 ring Labelled fast road, believed to be small bore cam
270                          Spider  -       13mm            -      Slight wear, no pitting      -    Kent cam
1 groove                 Slot      -       13mm             -      Slight wear no pitting      -    MG Metro cam
AEA649                   Pin       -        13mm           -       Slight wear, v slight pitting  Formula Junior Cam