3 replies to this topic

[pusb]

I am trying to change the pipes from the brake master cylinder down to the bias pressure thingy on the bulkhead. However access is extremely limited!

 

I have tried to remove the brake servo to get at it properly, and this is where I have got stuck. How exactly do you remove the servo? I have undone the two nuts securing it to the bulkhead crossmember, is it then just a case of undoing the bolt that goes through the bulkhead?

 

I have tried to follow the haynes manual, and it seems more concerned with dismantling the servo rather than just raising it a few inches for access.

[Steve220]

Which type of servo? Green or yellow tab?

[pusb]

Which type of servo? Green or yellow tab?

 

Green tag

[pusb]

Is it that the whole assembly, bracket included lifts up? Or is it better to remove the servo from the bracket?