2 replies to this topic

[MikeRotherham]

Can any one tell me how the electrical harness is supposed to lay?

 

I have included a couple of pictures of my current setup.

 

The harness doesn't seem to sit right and fouls the air intake which consequently does'nt fit square into the inner wing.

 

 

 

 

I've shown you mine can you show me yours?

Edited by MikeRotherham, 11 September 2016 - 05:28 PM.

[limby2000]

Hi Mike, i see yours is auto too, my car is currently at component level, if i can dig up one of my pics i will post.

[Scousemouse]

Usually thin (bendable) strips(1"x2-3") that you tuck over the harness,then close them up to keep the harness tight to the rear of the front panel that runs over the grill.

you can always use plastic ties.

Edited by Scousemouse, 11 September 2016 - 07:54 PM.