3 replies to this topic

[ashleyread1]

Hi All, 

 

My car will be having a full geometry setup tomorrow morning and i was wondering what sort of measurements i should go for. 

 

I would like to have around 1.5 neg camber on the front and 1 neg on the back. 

 

Not a clue what i should do in terms of tow for the tie rods hoping i can get some advice. 

 

I will have A032R tyres on the car on 10x6 Weller's. 

 

i have heard that people run these at 25 psi is this a good idea? 

 

This car will be used for fast road use any advice will be appreciated. 

 

Ashley

 

[nicklouse]

I would knock the front back down to 1 degree.
Caster about 4 degrees.
Front toe I would have at Zero and rear standard toe in.

[racingbob]

i have mine vitrually as above

 

didnt worry about rear toe left as is

 

but if you want, make it about 1/8 toe in for road

 

you dont need as much camber on rear 0 - half degree negative

 

make sure your happy with the ride hieght before goes in

[Anthony30]

Anyone good at setting up minis with adjustable suspension in the North West area, or near?