Found an oil leak under the car. Dont know what section of Haynes to start looking in.
The leak is coming from where the gear selector rod enters the gear box. Is this a common leak area?
Is there a seal than can perish there or is it a sign of gear box failure on the way.
If it is a seal what involved in replacing, ie is it a gear box out job or can it be done in situ?
please tell me its easy to rectify
Oil leak
Started by
charlie
, Sep 12 2006 11:07 AM
6 replies to this topic
#1
Posted 12 September 2006 - 11:07 AM
#2
Posted 12 September 2006 - 11:09 AM
classic mini leak! you mean to say urs didnt have it when you baught your mini?
i thaught it came as standard?
i thaught it came as standard?
#3
Posted 12 September 2006 - 11:16 AM
If it did I didn't spot it, I must of been too excited at getting my first mini.
Is it an easy job, and how long will it take an average DIY mini owner to complete?
Is it an easy job, and how long will it take an average DIY mini owner to complete?
#5
Posted 12 September 2006 - 11:25 AM
Thanks for link.
Do I have to dismantle selector rod for this?
Do I have to dismantle selector rod for this?
#6
Posted 12 September 2006 - 11:27 AM
i know its cheeky but could some1 do a guide to sorting these? as its a common accurence and we all need to do it?!?!?!
#7
Posted 12 September 2006 - 11:28 AM
just disconnect the rod from the selector part near the gearbox.
you just need to knock out the roll pin and it will come off.
look in HBOL i think it actually shows how to fit one of these.
Also make sure that you do not already have one of these fitted because fitting 2 will make it almost impossible to select gears
you just need to knock out the roll pin and it will come off.
look in HBOL i think it actually shows how to fit one of these.
Also make sure that you do not already have one of these fitted because fitting 2 will make it almost impossible to select gears
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users