Step 1
Mark out edge to be wired, with approx 8mm extra for making the wired edge. Use G104 Aviation Snips to cut to the 8mm line.
Step 2
Using Swage fit the jenny wheels to throw up an edge along the marked line (about 45 degrees).
Step 3
Use the wiring wheels to form a U shape along the crease previously formed, the work piece will have to be tipped to so as to come down the face of the top wheel.
Step 4
Insert the wire in the U and trap it by using a hammer on the open edge at approx 150 mm intervals.
Step 5
Put the closing wheels on the machine and set the gauge approx 6mm behind the top wheel.
Step 6
Run along the length of the wired edge closing it sufficiently to securely trap the wire all the length.
Step 7
Set the closing wheel to one thickness of metal (about 1mm) and run down the edge again to give a full length, even finish.