3 replies to this topic

[smile u drive a mini :-)]

If I put my right indicator on it blows 10amp fuseC4 on fuse board. Left indicator fine, radio fine and clock fine hazard blows it as well. If I set the alarm off all indicator lights work fine any ideas?

[cal844]

Check the front wires(behind grille) for chafing/ burst insulation then I'd clean all the connections up(earth connection at bulkhead triangulation too!) Then try, I'd suspect an issue with the stalk after that as you say it works with the alarm and hazards

[Icey]

If using the right indicator and using the hazard switch both blow the fuse but the alarm (which flashes the right-hand lights) doesn't, it's not going to be anything on the ends of the loom, it's going to be behind the dash. I'd be looking at the hazard switch itself, it's the only place those circuits come together.

[smile u drive a mini :-)]

Cheers have a look