Yes, for what it's worth, my workshop manual states 193-200 lbft then tighten to next split pin hole. Mind, it's probably not worth thinking about..Single hole CV joint 190lbft ???
Cv / Swivel / Bearing Movement Part 2 !
Started by
grahama
, May 19 2017 03:46 PM
17 replies to this topic
#16
Dusky
-
- Members
-
- 5,322 posts
Crazy About Mini's
- Location: Belgium
Posted 20 May 2017 - 06:51 PM
#17
cal844
-
- Members
-
- 9,713 posts
Crazy About Mini's
- Location: Ballingry, Fife
- Local Club: TFMOC
Posted 20 May 2017 - 08:07 PM
Single hole CV joint 190lbft ???
Seems too low to me!
#18
Spider
-
- Admin
-
- 15,685 posts
Moved Into The Garage
- Location: NSW
- Local Club: South Australian Moke Club
Posted 20 May 2017 - 08:59 PM
The factory figure is 197 ft / lb and then around to the next slot / hole alignment.
At 190 ft / lb it won't make any difference, given that tightening by a torque wrench is only 30% accurate at best and by the time it's reefed around to the next alignment, it will be well over 200 ft / lb.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
