Yo folks.
ok i got my rebuild kit and i'm puzzel. i figured out what most of the parts are. little black washer for the bash pot piston, butterfly valve and spindel, float needle bit (by the way how do you take the float bit apart?) but i'm confused by a large gasget,
its about 2.5inch wide with a with a little over a 2 inch hole in the middle. its a round ring gasget.
i have NO idea what its for. 1st i thought it was for the bottom of the dashpot but its too small. so i'm stumped.
any ideas?
rebuild confusion!
Started by
Big_Adam
, Oct 06 2006 03:15 PM
5 replies to this topic
#1
Posted 06 October 2006 - 03:15 PM
#2
Posted 06 October 2006 - 04:44 PM
may help...
#3
Posted 06 October 2006 - 05:23 PM
There's a little pin that slides out which'll take the float out, and the needle just falls out.
It's not the gasket for the float chamber lid is it?
It's not the gasket for the float chamber lid is it?
#4
Posted 06 October 2006 - 06:23 PM
nope not the float chamber one as i got one. the gasget not on that pic either guessworks.
i think it might be for su hs2's
i think it might be for su hs2's
#5
Posted 06 October 2006 - 07:03 PM
could be for the bottom of a hif carb!!!! just in the wrong packaging!! or it could be just a leftover from the cuting out of some other gaskets!!
#6
Posted 06 October 2006 - 07:21 PM
could be man, i mean the only place i've found it to fix is inside the piston....which is a bit pointless.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users