14 replies to this topic

[markc]

oberversly mounts in 3 places 2 on top of the rocker cover but where does the bottom one bolt too??? had a quick look couldnt see anything

[Sammy D]

[markc]

lol trying not to if i can
i have the mounts the bottom one has 2 holes for 2 bolts but where

[incrediblerog]

mine does the job with only one of the top clips working!

[markc]

does it not rattle???

[ANDY J]

hi mate what you need to do is put the cover on how it should be then have a look at the bottom of the cover and put the bottom mount roughly into place and mark or remember what 2 gearbox bolts that line up with the bracket then take the 2 bolts out , put the bracket on and then tighten up the bolts and put the cover on
hope it helps
andy

Edited by ANDY J, 27 October 2006 - 12:31 PM.

[Clubby1275GT]

does it not rattle?

Everything in a mini rattles, like its own little soundtrack! im sure a piece of plastic wont be that bad!

[markc]

bugger is that where it goes, will that not break the seal between the gb and engine and then leak :'(

[taffy1967]

Ere no!

[markc]

ok then ta

[998dave]

Just fit the top two and carefully push it down the front, being careful not to move any wires,

I never bothered with the bottom one, don't think it needs it, plus the bottom happens to be just the right length to poke through the bottom of a grille, which can be annoying, but not a problem...

D

[markc]

yeah thats what ive done makes it eaiser to remove to be honest as im aslways fiddling

[the old git]

Bin it and fit a marigold glove---you know it makes sense!

[998dave]

Or a condom?

[markc]

had to lube it first was a bit of a tight fit lol

Edited by markc, 29 October 2006 - 09:59 PM.