4 replies to this topic

[Kawh1]

Hello, I am looking at get a new set of bonnet & boot badges as per the attached photo, however can anyone advise how are these held in place on the bonnet and boot as I can't seem to find any screws which hold them in place. Are they held in place by adhesive on the back of the badge?

Attached Files

•  Badges.jpg   22.43K   0 downloads

[Ben_O]

Adhesive tape and should have 3 plastic locating pins too

 

I use a plastic filler spreader to carefully slide behind to release it but be careful you don't damage the paint 

 

Cheers.

Ben

[MacGyver]

Don't remember there being the 3 locating pins on mine, but it was a 2000 cooper and 99mpi... Holes are there on the bonnet tho. 😁
Make a note as to the location of the badge as it's curved to match the bonnet and doesn't fit if too high/low.
Dental floss (or windscreen nylon wire) works a treat, but wear thick gloves. 😉

Ben

[Kawh1]

Thanks for the info guys, cheers

[toplessmini]

3 year's later and this post is still helping people out, well me anyway. Thanks guys