3 replies to this topic

[DUF2]

I have put adjustable front tie rods on Duffy and could do with the length of the standard one to use as a starting point.  I don’t have the original tie rods anymore.

I need the length between the front bracket on the subframe to the centre of the bolt in the Track Control Arm.  

[Shooter63]

14.25" from the front of the welded on washer to the front of the hole where the bolt goes through at the lower arm

Shooter

[weef]

From the outer face of the welded washer to the centre ot the bottom arm fixing hole is 366mm, but it is more important to check the castor angle, I think 3 dec is the standard setting, as this angle is set by adjusting the length of the tie arm.

[DUF2]

Thanks for that info guys.

I can check this as a starting point. I know I need the front geometry checking, I will do that when I get time.