4 replies to this topic

[Propshaft]

Trying to sorte out the routing of the loom to the rear of the car .There is a hole with a grommet in the passenger side rear cubby does part of the loom go through there and to the front along the floor and through the centre cross member the car is a 92 mini Mayfair

[KTS]

loom to the rear usually goes from the engine bay up the inside of the passenger side A-pillar, along the roofline, then drops down the passenger side C-pillar into the boot

[mini-mad-mark]

loom to the rear usually goes from the engine bay up the inside of the passenger side A-pillar, along the roofline, then drops down the passenger side C-pillar into the boot

 

Not on later minis - sorry not sure exactly when, someone more knowledgeable will be along to state exact dates - as Propshaft has correctly surmised later minis it comes out of the boot at the rear quarter panel into the rear pocket and out of the grommet under the rear seat pan into the (larger) groove in the floor up to the front. I would have said  cars where the washer bottle is in the boot (whatever that cutoff is) but I've never had a late mini only old chuffers so I can't say for sure

[mini-mad-mark]

Looking at the "redrawn wiring diagrams" on here that I use quite often it appears that the latest wiring diagram was models from 92-96 (pre MPi of course) , so I would say quite possible that a 92 Mayfair would use this wiring routing but sure there will be someone on here to confirm (that has experience of later models)

[viz139]

'92 is along the floor. last of the 998 '91 were up the pillar. Don't know about RSP or carb Cooper.